Ashdown Envelope Filter Bass

The Ashdown Envelope Filter is a bass-specific effects pedal offers a wide range of automatic filters open and close, or "sweeping" effect. The commands perform functions similar to the effects of other envelope filter, you'll see a wider range of effects from filters Envlope Ashdown are on foot pedal effects most envelope filters.

An effect of filter envelope is a variable band-pass or low pass filter circuit electronics, where it will scan through the filter, but is controlled by the signal through unit.the Envelope Filter Pedal controlled dynamically by the bassist, the harder the note is played over the frequency range passed by the filter sweep. TAC May usually chosen in an upward direction when the filter frequency increases with an increase in the level or where the filter starts with a high frequency, and turns to the degree of momentum after the signal .

The Ashdown Envelope Filter Bass Effects Processor uses True Bypass switching, which means that when the effects pedal to ignore all the electronics in the pedal circuits are off. The input will directly and only to the power outlet does not affect your bass signal connected. Most effects pedals connected to the inner circle remains, although the effect is bypassed. What is changing and will affect your signal low. With true bypass circuitry, so the effect will be bypassed, it is the same as if the bass is plugged directly to the amplifier input.

The Ashdown Envelope Filter Pedal is housed in a metal enclosure and has an input level control with a trademark Ashdown VU meter for optimum signal matching from any bass, active or passive. The pedal also has a control output level, essential to maintain the perfect balance between effect and the true bypass mode.

ASHDOWN ENVELOPE FILTER BASS EFFECTS PEDAL SPECIFICATIONS

Filter Range: 30Hz to 12kHz.
Filter roll off: 24dB/octave.
Filter Peak: Q Infinitely variable from 3 to 10.
Single rotary control selects Band Pass, Low Pass or a continuously variable mix of both.
Up & Down ranges continuously variable from zero to full sweep.
Input Impedance: 470k Ohms.
Signal level: -10dBv to 0dBv.
Output Impedance: 10k Ohms.
Signal level variable: -10dBv to 0dBv.
Power Supply: Internal 9v battery.
External Supply: 9v DC adaptor Centre pin negative.